How to Remove and Install 2024-2025 Toyota Tacoma TRD Pro Front Grill

2024-2025 Toyota Tacoma TRD Pro Grille Installation Guide

Upgrade your 2024-2025 Tacoma with Quaxpire TRD Pro grille using our step-by-step guide. Learn how to install a 2024-2025 Toyota Tacoma front grill safely with pro tips & wiring instructions.

🛠️ Tools & Prep Work

What You’ll Need: 

  • 10mm socket wrench (most used tool!)
  • Phillips screwdriver
  • Trim removal tool (or flathead screwdriver)
  • Zip ties (for wire management)
  • Gloves (optional, protects hands)

Safety First:

⚠️ Disconnect the battery (negative terminal) to avoid electrical shorts.
⚠️ Work on a clean, flat surface to avoid losing screws/clips.

📦 Unboxing & Pre-Assembly

  • Attach Letters/Emblems (Easiest Step!)
  • Secure the "TOYOTA" or heritage badges to the new grille bracket using included screws.

🔧 Step-by-Step Installation

Step 1: Remove the Old Tacoma Grille

1. Pop the hood and locate:

  • Three 10mm bolts near the top grille liner (remove these first).

  • Two Phillips screws behind the liner (hidden access).

2. Release the fender clips:

  • Use a trim tool to gently pry off plastic clips along the sides (watch for flying clips!).

3. Remove the bumper cover:

  • Undo six 10mm bolts under the bumper.

  • Carefully pull the cover forward (better with two people).
pull the 2025 Tacoma Grille cover forward

Step 2: Disconnect Wiring

  • Unplug harnesses: Disconnect three wiring plugs near the passenger headlight.
  • Label connectors if needed for reinstallation.

Step 3: Remove the Grille Shutter

  • Unscrew six 10mm bolts holding the shutter assembly.

  • Set aside (not needed for the TRD Pro grille).
  • Unscrew 11 Phillips screws. And then take out the original grille piece. 

Step 4: Install the New TRD Pro Grille

  1. Align the grille and clip it into place.
  2. Secure with screws: Reinstall the 11 Phillips screws along the top edge.
  3. Reattach the bumper cover in reverse order.

⚡ Wiring the Lights (Raptor Lights/Light Bar)

Option 1: Plug into auxiliary switches (for manual control).

  • Connect the adapter to your Tacoma’s AUX wiring harness (green/black wires).

Option 2: Hardwire to always-on power (with ignition).

Pro Tip: Use zip ties to clean up loose wires!

✅ Final Checks  ✅ 

  • Reconnect the battery terminal.
  • Test all lights before closing up.
  • Snap a photo of your upgraded Tacoma! 📸

💡 Pro Tips & Warnings

  • Label screws/clips in bags to avoid confusion.
  • Go slow with trim clips—they break easily!

Question? 

Q: Does this fit the 2025 Tacoma TRD Off-Road?
A: Yes! Fits 2024–2025 Tacoma TRD Pro/Off-Road models (not Tacoma Sport).

Q: Can I install this alone?
A: Doable solo, but a helper makes bumper removal easier.

Q: Do Raptor lights drain the battery?
A: Not if wired to AUX switches or ignition power.

Back to blog